Brand New Range
The Toronto is made for big families and friends who like to party! Sit back, relax and let the stress of the day just fade away.

Free Delivery and Installation is included with this product

SPECIFICATIONS

	Seating: 6-7 Persons	Capacity: 340 Gallons/1690 litres
	Cabinet Size: 228cm x 228cm x 103cm	Cabinet Skirt: Clear Cedar/With Full Base
	Dryweight: 1200 lbs/545 Kg	No. of Water Jets: 37
	Controls: Electronic Digital Controls	No. of Air Jets:12 Manifold air jets & blower assist
	Heater Type: 3 Kw high Output Heater	Pump Type: 2 x 4 Hp pumps
	Aromatherapy: Dispenser Included	Lights: 12 volt Safety Light with 2 Colour lens
	Cover: Tapered Cover with Safety Locks	Ozone: Plasma cell Ozone Generator

PRE DELIVERY INSTRUCTIONS

Positioning of your Spa: When selecting a site for your Spa, take into account the following:

• LOCAL CODES: There may be certain restrictions and/or requirements that are particular to your locality. If in doubt check with your local council.
• DELIVERY AND PASSAGEWAY: The Spa will arrive as a unit, and in most cases cannot be dismantled. Ideally the Spa will be placed on a trolley either on its side or on its base. The unit will then be rolled into place easily crossing grass, gravel and small terrain anomalies. For safe and non-intrusive installation, or in the case of other obstacles (steps, walls, steep hills etc.) contact Canadian Spa Company Ltd. for advice and conditions.
• LOCATION AND BASE: A sheltered environment can result in lower operating and maintenance costs. You must allow 1 metre clearance for access to the Spa's access panel for servicing. o The site you select for your Spa MUST be a flat, level continuous surface that contacts the bottom of your Spa fully. o Your new Spa weighs between 900 and 1400 Kgs when full and therefore a solid support is essential when the Spa is mounted on a deck or ground level patio/floor. It is recommended that you install your Spa at ground level which allows easy access to equipment. o A 10 to 15cm thick reinforced concrete slab is ideal, but not required. In most cases your Spa can be placed on existing patios. o The base should be at least the size of the bottom of your Spa. (See Spa sizes) o Water should always drain away from the spa. DO NOT locate your Spa in a low run-off area since melting snow or rain could flood the area and cause pump and equipment damage. o DO NOT locate the Spa near or under overhead wires, keeping clear of all electrical appliances.

ELECTRICITY SUPPLY- VERY IMPORTANT

• Have a licensed electrician run the required 230-volt power line to the spa installation site.
• This power line must be permanently connected (hard-wired) to the mains supply.
• Do not use extension cords or plug-in type connections
• . At the site where the spa is to be located, leave 4 metres of cable and the appropriate cable gland.
• All electrical wiring to a spa MUST be installed by a qualified, licensed electrician and approved by local building/electrical inspectors.
• PLEASE NOTE: Failure to supply the recommended power will void the Manufacturer's warranty.
• For all Canadian Spa Company Spas, with the exception of the Montreal, Quebec, Muskoka and Haliburton Niagara, the power supply to the spa must be a dedicated 20 amp RCD protected circuit.
• Niagara requires 32 amp supply.
• No other appliance or lights should share the power provided by the circuit.
• For the Montreal, Quebec, Muskoka and Haliburton a 13 amp line will suffice.